PRODUCT INTRODUCTION
This product is a smart photoelectric smoke alarm, which is combined with a RF transceiver. With the installation of more than one smoke detectors, the communication is wireless. In case of smoke emission in one of the protected rooms, all installed smoke alarms are activated. A smoke alarm that sounds alarm in the loft might not always be audible in the garage. This situation changes with this wireless photoelectric smoke alarm. The smoke alarm part（mainboard part ） and RF board part are powered by two independent 3V battery separately .
It is capable of real-time detecting the presence of smoke. Once it detects danger of fire smoke, red LED will flash rapidly and it will issue alarm sounds.
SUPERIOR FEATURES
Battery Operated
Both lifetime of battery for the mainboard and battery for the RF board can reach 10 years.
Operating Light (LED)
Red LED flashes approximately every 53 seconds confirming unit is powered.
Low Battery Warning
When battery for mainboard is low: Alarm beeps and Red LED flashes every 53 seconds.
When battery for RF board is low: Alarm beeps and Green LED flashes every 53 seconds.
Alarm Pause (Hush mode)
Silence your smoke alarm device by momentarily pressing the test button when non-emergency
smoke (e.g. steam), causes nuisance alarms. The red light flashes every 10 seconds to remind you
that the smoke alarm device has been silenced. The alarm will automatically reset after 10minutes.
Sensitivity Test Button
Test the sensitivity, circuitry, batteries, horn.
Loud 85 Decibel Piezo Electric Alarm Automatically resets when hazardous condition has passed. Easy Installation
Fixings supplied.
PACKING LIST
|
PART NAME |
QUANTITY |
|
Smoke alarm device |
1 Piece |
|
Mounting bracket |
1 Piece |
|
Screw |
2 Pieces |
|
Anchor plug |
2 Pieces |
|
Manual |
1 Piece |
INTERCONNECTION SETUP
The installing distance between any 2 alarms in an interconnection group should be within 150m.
DIP Switch setup ：For intended interconnected alarms, set their DIP switch to the same ID（16 groups in total. Only alarms with the same ID can make up an interconnection group. If an alarm in an interconnection group alarms, the other alarms in the group will also alarm.
